A SERVICE OF

logo

Open as PDF
next previous
8
SECTION II
SERVICE ADJUSTMENTS
WARNING: UNPLUG OVEN BEFORE SERVICING.
WARNING: CERTAIN PROCEDURES IN THIS SECTION REQUIRE ELECTRICAL TEST OR
MEASUREMENTS WHILE POWER IS APPLIED TO THE OVEN. EXERCISE EXTREME
CAUTION AT ALL TIMES. IF TEST POINTS ARE NOT EASILY ACCESSIBLE
DISCONNECT POWER, ATTACH TEST EQUIPMENT AND REAPPLY POWER TO TEST.
OVEN DOOR ADJUSTMENT
1. Lower the kick panel.
2. Pull door spring slightly out with large screwdriver. (Fig. 1)
3. Using a
5
⁄16" socket loosen (2) hex nuts holding the turn buckle in place. Turn the buckle "J" bolts (left and
right side) slightly retighten the nuts and test door for proper closure. Generally the door is properly adjusted
when it closes on its own as you rise it to the half closed position. (Fig. 2)
Fig. 1
Fig. 2