ADDITIONAL INFORMATIONS April 2007
4-94
4.4.9 POOR FUSING ON 100g/m
2
PAPER
SYMPTOM:
Part of the image peels off the paper.
Note: This symptom is most noticeable under these conditions:
z When solid images are printed onto 100 g/m
2
(28lb. bond) paper in full
color mode
z When using a PostScript3 unit type3260 (B761) or using EFI printer
controller (G815: E-7000)
CAUSE:
Not enough heat is supplied to the surface of the fusing roller.
SOLUTION:
Add the "Middle Thickness Paper Mode" by the following action.
ACTION:
Confirm the following Firmware version, and then follow the procedure described
from the next page.
Engine: Ver.1.20.2_08 (B1325402Q) or newer
System/Copy: Ver.1.23 (B1325750M) or newer
IMPORTANT:
• Update both the Engine and System/Copy firmware at the same time.
• Never
change the setting for Sp1105-036 (Hot Roller Wait Temp: Norm,
default = 145 deg). If you increase the value above 145°C, the hot roller
surface can be damaged (Refer: chapter 4.4.8).
• After you finish the procedure below, turn the machine main power
OFF/ON.
