10 Model 7500 Instruction Manual
Teledyne Analytical Instruments
3. INSTALLATION
DANGER
This unit is not explosion-proof type. Do not use it in a place with explosive gases to avoid explosion, re
or other serious accidents.
CAUTION
• For installation, observe the rule on it given in the instruction manual and select a place where the
weight of gas analyzer can be endured. Installation at an unsuited place may cause turnover or fall and
there is a risk of injury.
• For lifting the gas analyzer, be sure to wear protective gloves. Bare hands may invite an injury.
• Before transport, x the casing so that it will not open. Otherwise, the casing may be separated and fall
to cause an injury.
• The gas analyzer is heavy. It should be transported carefully by two or more persons if manually
required. Otherwise, body may be damaged or injured.
• During installation work, care should be taken to keep the unit free from cable chips or other foreign
objects. Otherwise, it may cause re, trouble or malfunction of the unit.
3.1 Installation conditions
To install the analyzer for optimum performance, select a location that meets the following conditions:
(1) Use this instrument indoors.
(2) A vibration-free place
(3) A place which is clean around the analyzer.
(4) Power supply
Rated voltage: 100V to 240VAC
Operating voltage: 85V to 264VAC
Rated frequency: 50/60 Hz
Power consumption: 70 VA max.
Inlet: Conformity to EN60320 class I type 3-pin inlet
(5) Operation conditions
Ambient temperature: -5 to 45°C
Ambient humidity: 90% RH or less, no condensation
