Teledyne API Model 401 O
3
Photometric Calibrator Instruction
Manual, 01124, Rev. J2
Warranty/Repair
Questionnaire
TELEDYNE
INSTRUMENTS
Advanced Pollution Instrumentatio
Model 401
A Teledyne Technologies Company
9.7 Warranty/Repair Questionnaire
CUSTOMER: PHONE: __________________________________________
CONTACT NAME:
FAX NO. __________________________________________
SITE ADDRESS: ______________________________________________________________________________________
MODEL 401 SERIAL NO.:
FIRMWARE REVISION: _____________________________
1. ARE THERE ANY FAILURE MESSAGES? ____________________________________________________________
_____________________________________________________________________________________________________
_____________________________________________________________________________________________________
PLEASE COMPLETE THE FOLLOWING TABLE: (NOTE: DEPENDING ON OPTIONS INSTALLED, NOT ALL
TEST PARAMETERS SHOWN BELOW WILL BE AVAILABEL IN YOUR INSTRUMENT.
)
Parameter Observed Value Units Normal Range
DCPS MV 2300-2700mV
BOX TEMP DEG C
Ambient +3-5° C
O
3
OFFSET PPB -10 - +20PPB
O
3
SLOPE - 1.0 ± .15
REG PRESSURE IN-HG-A 10 – 21”-Hg-A
O
3
GEN TMP DEG C
48 ±1° C
O
3
GEN FLOW L/MIN 2 – 5 LPM
ANA LAMP TMP DEG C
52 ±1° C
SAMPLE TEMP DEG C
10 - 50° C
SAMPLE FLOW SCC/MIN 700-900 cc./min
SAMPLE PRESS IN-HG-A Ambient +0-2”-Hg-A
O
3
DRIVE MV 0-5000mV
O
3
GEN REF MV 120-5000mV
O
3
REF MV 2500-4700mV
O
3
MEAS MV 2500-4700 mV
O
3
SET PPB/PPM .05 PPM –1 PPM
2. HAS THE UNIT BEEN LEAK CHECKED? YES NO
3. WHAT ARE THE FAILURE SYMPTOMS?____________________________________________________________
____________________________________________________________________________________________________
____________________________________________________________________________________________________
____________________________________________________________________________________
IF POSSIBLE, PLEASE INCLUDE A PORTION OF A STRIP CHART PERTAINING TO THE PROBLEM. CIRCLE
PERTINENT DATA.
4. THANK YOU FOR PROVIDING THIS INFORMATION. YOUR ASSISTANCE ENABLES TELEDYNE API TO RESPOND
FASTER TO THE PROBLEM THAT YOU ARE ENCOUNTERING
TELEDYNE API CUSTOMER SERVICE
EMAIL: api-customerservice@teledyne.com
PHONE: (858) 657-9800 TOLL FREE: (800) 324-5190 FAX: (858) 657-9816
9-18
