26 Sun Blade T6300 Server Module Administration Guide • April 2007
▼ To Disable Automatic System Recovery
1. At the ok prompt, type:
2. To cause the parameter changes to take effect, type:
The system permanently stores the parameter change.
Note – To store parameter changes, you can also power cycle the system using the
front panel Power button.
After you disable the ASR feature, it is not activated again until you re-enable it.
Obtaining Automatic System Recovery
Information
Use the following procedure to retrieve information about the status of system
components affected by ASR.
▼ To Obtain ASR Information
● At the sc> prompt, type:
In the showcomponent command output, any devices marked disabled have been
manually unconfigured using the system firmware. The showcomponent command
also lists devices that have failed firmware diagnostics and have been automatically
unconfigured by the system firmware.
ok setenv auto-boot-on-error? false
ok reset-all
sc> showcomponent
