3 — OPERATION
19
Use the ground control panel to operate the
boom lift functions. Raise, lower, extend and
rotate the booms by pressing and holding the
desired
SPEED and function buttons at the same
time. Become familiar with the location and
function of all controls. Learn to smoothly start
and stop all boom motions.
Fully lower both booms onto the boom rest to
position the platform for boarding. Turn the key
switch to the platform control position.
Raise the safety bar and enter the work
platform. Put on the safety harness and attach
the lanyard to the Fall Protection Attachment
Point on the side of the platform support beam.
Use the platform control panel to operate the
boom lift functions. Raise, lower, extend and
rotate the booms by pressing the desired
SPEED
and function buttons at the same time. Become
familiar with the location and function of all
controls. Learn to smoothly start and stop all
boom motions.
Should the platform become tilted out of the
normal vertical axis, press and hold the desired
SPEED button and one of the PLATFORM TILT
buttons at the same time to adjust.
Monitor the Battery Condition Indicator during
operation and charge the batteries as
necessary.
Always fully retract, rotate and lower the booms
to their stowed positions before exiting the
platform.
When all boom lift operations are complete, fully
retract the telescoping boom extension. Center
booms over the boom rest and fully lower all
booms until seated in the stowed position for
transport. Safety switches prevent outrigger
retraction until all booms are completely lowered
and stowed for transport.
Unfasten the safety harness and exit platform.
Engage the upper and lower boom travel
latches.
Turn the key switch to the ground controls
position.
Press and hold the outrigger RETRACT button
and the
AUTO LEVEL button until all outriggers are
fully retracted to their upright positions. Inspect
the area beneath lift and trailer for obstructions
before retracting outriggers.
Turn the key switch to the OFF position and
remove key.
