ID07 User Manual ◄ 11
NOTE:
If the uncoupled hoses are left in the sun, pressure
increase within the hoses can make them difcult to
connect. Whenever possible, connect the free ends
of hoses together.
WRENCH OPERATION
The ID07 is designed for 1/2-inch square or 7/16-inch
hex drive.
During normal operation it is common to see some
grease leakage from around the anvil during hard use.
Refer to the Service Manual for the correct lubrication
procedures.
1. Observe all Safety Precautions.
2. Move the hydraulic circuit control valve to the “ON”
position to operate the wrench.
3.
WARNING
Always use sockets and accessories designed for
impact type applications. DO NOT USE STANDARD
SOCKETS OR ACCESSORIES. THESE CAN
CRACK OR FRACTURE DURING OPERATION.
Select the direction (clockwise or counterclockwise)
of impact desired by pushing the reversing spool ei-
ther left or right. See item 75 in the parts illustration.
NOTE:
To more accurately tighten bolts, lubricate threads,
check with a torque wrench and duplicate time of
impacting for other bolts of the same length and
thread size.
4. Squeeze the trigger to activate the wrench.
5. Release the trigger to stop the wrench.
COLD WEATHER OPERATION
If the wrench is to be used during cold weather, preheat
the hydraulic uid at low engine speed. When using the
normally recommended uids, uid temperature should
be at or above 50 °F/10 °C (400 ssu/82 centistokes) be-
fore use.
Damage to the hydraulic system or wrench can result
from use with uid that is too viscous or too thick.
OPERATION
