48
5 Start playing the cassette on the
VCR.
The picture played on the connected
device appears on the LCD screen of
your camcorder.
6 Touch [REC START] at the point
you want to start recording.
7 Stop recording.
Touch (Stop) or [REC PAUSE].
8 Touch [ RET.] t .
Dubbing sound to a
recorded tape
You can add sound to a tape already
recorded in the 12-bit mode (p. 42) without
erasing the original sound.
You can record audio by using the internal
stereo microphone.
• You cannot record additional audio:
– When the tape has been recorded in the 16-bit
mode (p. 42).
– When the tape has been recorded in the LP
mode.
– When your camcorder is connected via an
i.LINK cable.
– When the tape has been recorded in 4CH MIC
mode.
– On blank sections of the tape.
– When the tape has been recorded in a TV
color system other than that of your
camcorder (p. 61).
– When the write-protect tab of the cassette is
set to SAVE (p. 62).
– On sections recorded in HDV format.
• When you add sound, the picture will not be
output from the A/V OUT jack. Check the
picture on the LCD screen or the viewfinder.
Internal stereo
microphone
Recording pictures from a VCR,
etc. (Continued)
