Chapter 4 Advanced Operations
4-20
Chapter 4 Advanced Operations
Snapshots
This unit’s snapshot function allows you to save the control panel state,
and recall it whenever necessary.
You can save up to one hundred control panel states in snapshot registers
in the processor numbered from 0 to 99.
When you recall a saved snapshot, the control panel settings all change
automatically.
The following are the settings which you can save in a snapshot.
Note
The color corrector settings and fader lever position are not saved in a
snapshot.
Operational section
Settings
Primary cross-point bus
section
Signal selected by the FOREGROUND bus buttons
Signal selected by the BACKGROUND bus buttons
Signal selected by the TITLE1 SOURCE bus button
Signal selected by the TITLE2 SOURCE bus button
Signal selected by the DSK FILL bus button
Signal selected by the SUPER BG bus button
Signal selected by the FRGD 2 bus button
Signal selected by the MEMORY bus button
Effect transition section Transition time
Transition direction (REVERSE button setting)
FRAME button setting
Pattern/numeric keypad
Specified pattern number
LIGHTING section All settings
TITLE section
All settings
MATTES section
Color matte colors
DSK section All settings
Effect control section User modifiable effect parameter settings
EDGE section All settings
Location section All settings
Chapter 4 Advanced Operations
Chapter 4 Advanced Operations
4-21
Saving a Snapshot
To save a snapshot, use the following procedure.
Note
The unit is shipped with snapshots saved in registers 0 to 99. By carrying
out the following procedure you overwrite these settings.
1
Set the buttons and controls on the control panel so that it is configured
to the state you want to save.
2
Press the LEARN button.
The button lights, and the pattern/numeric keypad is ready to accept a
snapshot number.
3
With the buttons 0 to 9, enter the snapshot number you want to save (0
to 99).
You can use the UP and DOWN buttons to adjust the number
displayed.
4
Press the ENTER button.
This saves the current settings in the snapshot register.
To cancel the snapshot saving operation
In step 4, press the LEARN button instead of the ENTER button. The
LEARN button goes out and the operation is canceled.
