EENNGGLLIISSHH
17
Enter the test tone mode.
10
In these modes, the volume level of each channel
can be adjusted easily with the test tone function.
Repeat steps 7 to 9 in “Adjusting each
channel level” until the sound level of each
speaker is heard to be equally loud.
11
Cancel the test tone function.
12
Adjusting each channel level
In Dolby Digital or Dolby Pro Logic
Select the desired channel.
7
Adjust the level of the selected channel
as desired.
8
Repeat the above steps 7 and 8 to
adjust the other channel levels.
9
If the channel display disappears, start from the
above step 7 again.
Each time this button is pressed, the corresponding
channel is selected and displayed for 3 seconds as
follows;
Front Left Center Front Right
SubWoofer Rear Left Rear Right
When it is in the normal stereo or Dolby Virtual
mode, or the speaker setting is “N”, center, rear or
subwoofer channel will not be selected.
The test tone will be heard from the speaker of each
channel for 2 seconds as follows;
Front Left Center Front Right
SUBwoofer Rear Left Rear Right
Speakers set to “N” are not available and will not be
heard.
