Putting the S1 DIGITAL into operation
S1 DIGITAL | 13
Pairing the headset with a Bluetooth device
The following chapter describes, by way of example of a mobile phone, how to
pair the headset with a Bluetooth device.
̈ Make sure that
– the headset is connected to the on-board DC power supply system or that
the control unit is equipped with fully charged batteries/rechargeable
batteries,
– the mobile phone’s Bluetooth visibility is enabled (see the instruction
manual of the corresponding Bluetooth device),
– the headset is placed close to the mobile phone (approx. 50 cm or 19.7”).
̈ Switch the headset on by setting the Power OFF/ON switch G to the position
ON.
̈ On your audio source, activate the Bluetooth function “Add a new device”.
̈ When the mobile phone prompts for a password or PIN code, enter the default
PIN code “0000”.
̈ Proceed as described in the instruction manual of the mobile phone.
̈ In this case, repeat the necessary steps to pair the headset with the mobile
phone again.
̈ Press and hold the multi-function button until the
LED alternately flashes blue and red.
Once the headset has found the mobile phone, the devices exchange
device identification information. The LED flashes 3 times blue.
You hear an ascending beep. The devices have identified each other
and the headset is paired with the mobile phone.
If no device is found within approx. 5 minutes, the LED flashes
3 times red and you hear a descending beep. The headset will then
try for 3 minutes to connect to one of the up to 8 previously paired
Bluetooth devices. If this fails, the Bluetooth function automatically
switches off after 10 minutes.
