,--_n_,
, '
:
~
:2
i :,.3_-
I I
L__- -
L
Adjustingthe Microphone Sensitivity
The microphone can process a maximum sound pressure level of
>140 dB without distortion. When this level is reached the signal
voltage at the microphone output is approx. 1000 mV. In order to
prevent the microphone input stage of the connected equipment
from being overloaded the microphone sensitivity can be stepped
down in two steps: -10 dB and -20 dB. The sensitivity switch
must be operated either with the included switching tao I or with
same other suitable tao I.
Connection to equipment with built-in phantom power supply
Usingthe Roll off Filter
The built-in roll off filter can be switched on and off with the help of
a switch which can be accessed after the grip sleeve has been
unscrewed.
Usingthe microphone
In order to get the most out of this microphone please observe the
following instructions:
MKE 4032 P 3'("Rock" version)
. Hold the microphone very dose to the mouth (Iip contact)
. Avoid covering the protective mesh cage with your hand
. If distortion accurs correct the setting at the mixing desk or
switch in the pre-attenuation (see also "Adjusting the Micro-
phone Sensitivity")
MKE 4032 P ("Studio" version)
. Speak across the top of the microphone
. Avoid covering the protective mesh cage with your hand
.In the event of wind interference or extreme demands upon pop
noise use the supplied windscreen
]@ofj
The bass roll off caused by the filter can be used in order to com-
pensate the close talking effecl and to suppress impact, handling
and wind noise.
14
15
