Programs supplied on the CD
2.
1
2 Programs supplied on the
CD
The CD-ROM supplied with your printer card provides you with:
•
Set IP
: A utility program allowing you to select a network printer card
and manually configure the addresses for use with the TCP/IP
protocol.
System requirements
To install
SetIP, one of the following operating systems is required:
• Operating system: Windows 2000/XP/Vista/Windows Server 2003,
MAC OS 10.3~10.5
Installing software
1
Insert the supplied CD-ROM into your CD-ROM drive.
The CD-ROM should automatically run, and an installation window
appears.
If the installation window does not appear, click
Start
>
Run
. Type
X:
\
Setup.exe
, replacing “
X
” with the letter which represents your
drive and click
OK
.
If you use Windows Vista, click
Start
>
All Programs
>
Accessories
>
Run
, and type
X:\Setup.exe
.
If the
AutoPlay
window appears in Windows Vista, click
Run
Setup.exe
in
Install or run program
field, and click
Continue
in
the
User Account Control
window.
2
Click
Next
.
3
Select the language you want.
4
Click
Typical installation for a network printer
.
5
Follow the onscreen instructions to complete installation.
6
Click
Finish
when installation is done.
Uninstalling software
You should remove the Network utilities if you are upgrading the software
or if the installation fails.
Note
: Close all programs before uninstalling software.
1
Click
Start
>
Programs
>
SP 3300 Series
>
Set IP
>
Set IP
.
2
Click
OK
to confirm uninstallation.
3
Click
Finish
when uninstallation is done.
