Unit 4: Operation
SATO XL400-410e Operator Manual PN 9001135A Page 4-22
NORMAL MODE
MENU DESCRIPTION
NORMAL MODE Basic print functions.
ONLINE
000000 00000000
Receives data and can issue a label. Displays the countdown
number and the count-up number in the lower region on the
LCD.
CENTER HOLE
000000 00000000
Center Hole is the factory default media. If another media has
been selected, that will be displayed. The countdown and
count-up quantites is also displayed.
PRINT DARKNESS
X X X X
Allows the selection of print density and displays the selection.
PRINT SPEED
X X X X X
Allows the selection of printing speed and displays the
selection. The print speed options are determined by the printer
XL400e or XL410e being used. The lower digits are the slower
speeds and ascends with the numeral digits. The speed is
based on inches.
PRINT OFFSET
V: +000 H: +000
Allows the entry of the horizontal and vertical print offset and
displays the entry. The offset is determined by the number of
dots with a range of 0 to 400. Either + or - options allow for the
determination of a positive or negative numeral.
ZERO SLASH
YES NO
Allows for the zero slash to be enabled or disabled. Zero slash
enabled provides for a slash to be printed diagonally across the
numeral zero to differentiate it from the letter “O”.
CANCEL PRINT JOB
YES NO
Permits the print job to be aborted.
CANCEL PRINT JOB
COMPLETED
Confirms the print job has been canceled or aborted.
DEFAULT SETTINGS MODE
MENU DESCRIPTION
DEFAULT SETTING
YES NO
REturns the print density, print speed, offset correction, zero
slash, and character pitch to their initial values. Press the FEED
key to initiate. Switch power off to discontinue.
DEFAULT SETTING
COMPLETE
After confirming the settings, turn the power off.
NON-STANDARD CODE CLEAR
MENU DESCRIPTION
ALT. PROTOCOL
DEFAULT COMPLETE
Allows the non-standard protocol code to its default values. The
default values are: STX (7B), ETX (7D), ESC (5E), ENQ (40),
NULL (7E), CAN (21), and Offline (5D).
