14
ATTACH A RESMED PASSOVER HUMIDIFIER
Please refer to the illustrations in section J of the illustration sheet.
To connect your
S8 ESCAPE to a ResMed PASSOVER humidifier you need medium sized
21” (52 cm) air tubing.
1
Fill the
PASSOVER
with water and connect the medium
21” (52 cm)
and long
6’6” (2 m)
air tubing (
J-1
).
2 Place the S8 ESCAPE on top of the PASSOVER (J-2) and connect the free end of the
medium air tubing to the air outlet (J-3).
Note: To avoid water spilling into the
S8 ESCAPE, do not place it underneath the
humidifier.
3 Assemble your mask system and connect it to the free end of the long air tubing (J-4).
4 Connect the power cord to the socket at the rear of the S8 ESCAPE and plug the other
end into a power outlet.
Please refer to the ResMed Passover User’s Manual for further details.
!
WARNING
Make sure that the power cord and plug are in good condition and the equipment
is not damaged.
The
S8 ESCAPE is now ready for use with the PASSOVER.
338215r3.book Page 14 Tuesday, August 30, 2005 10:40 AM
