1
2 3
654
87
Turn the dial, so that the
forehead support is fully
extended.
Hold the mask over your
nose and pull the headgear
over your head.
Bringing the lower straps
below your ears, connect
the headgear clip to the the
mask frame.
Unfasten the Velcro
®
,
pull the upper headgear
straps evenly until they are
comfortable and firm, and
reattach the Velcro.
Repeat step 4 with the
lower headgear straps.
Connect the main air
tubing to the swivel. Then
connect the free end of
the air tubing to your flow
generator and turn the flow
generator on.
Fitting the Mask
Lie down in your sleeping
position. Adjust the dial
until the mask is evenly
positioned on your face.
It should be comfortable,
with a satisfactory seal.
Adjust the headgear straps
if necessary.
The fitted mask is shown
above.
Removing the Mask
Disconnect one of the
headgear clips and pull the
mask and headgear up over
your head.
