Razor E125 Manual

A SERVICE OF

next previous

3

ASSEMBLY AND SET-UP

❑

Attaching the

Handleba

rs

WARNING:

Failure

to properly tighten the wedge

may allow the handlebars to

dislodge while riding and may

cause you to lose control and

fall. When correctly tightened,

the handlebars will not rotate

out of alignment with the

front wheel under normal

circumstances.

WARNING:

Keep your

ﬁ ngers clear of the pivoting

mechanism when folding or

unfolding the scooter, and make

sure others are standing clear.

Note:

The cable and wire

assembly from the handlebar

must not wrap around the

steering tube or handlebar

as shown in step 3. Sharp

bends or twisting of the brake

cable can cause the brakes to

malfunction.

❑

Charging the Battery

Your electric scooter may not have a fully charged battery. Th

erefore it

is a good

idea

to charge the battery

prior to use.

•

I

nitial charge time: 12 hours •

Run time: up to 40 minutes

• Recharge time: up to 8 hours, •

Average battery life:

250 charge/discharge cycles

Battery should be recharged

a minimum of 8 hours after

each use. When the vehicle

is not in regular use, recharge

the battery a

t least once a

month until normal use

is resumed.

1

P

lug the charger port

into the

port on the scooter.

The charger

works with the power switch

in either the on or off position.

The charging input, on/off

switch and overload breaker are

located under the deck at the

front left-hand side.

2

P

lug the charger plug into a

wall outlet.

WARNING:

A

lways

disconnect

your scooter from

the charger before cleaning with

liquid.

Note:

If your charger does not

look like the one illustrated,

your unit has been supplied

with an alternative charger.

The speciﬁ cations and charging

procedure would not change.

The charger has a small window

with one LED or two LEDs to

indicate the charge status.

Refer to the illustration on

the charger unit for the actual

“charging” and “charged” status

indications for your model

charger.

C

hargers have built-in over-

charge protection to prevent

battery from being over-charged.

Be sure to properly align the

groove on the charger input

plug with the corresponding

socket on the case;

otherwise, no charging

action will occur.

Charger

Plug

Charger

Port

4

Using a 6mm hexagonal

key wrench, tighten the

wedge by turning the bolt

clockwise. The wedge is

properly tightened when the

handlebars cannot be twisted

out of alignment with the

front wheel.

5

Pivot the handlebar assembly

upright.

1

L

oosen the locking knob

and swing to the 6 o’clock po-

sition to unfold the handlebar.

2

Remove the plastic protector

covering the base of the handle-

bar assembly. Insert the “quill”

part of the handlebar assembly

into the fork. You may have to

loosen the wedge to allow it to

slip into the fork.

3

Slide the quill into the

fork until it bottoms on the

headset.

6

Swing the locking knob to

the 12 o’clock position and

tighten by hand as ﬁ rmly as

possible.

WARNING:

Failure

to recharge the battery at leas

t

once a month may result in

a battery that will no longer

accept a charge.

E_Series_Manualv10.indd 4 3/10/06 2:10:54 PM