Hurricane 9300G (802.11g) ADSL2+ Modem Router
Chapter 4: Configuration
99
Bridge Interface VLAN Port (Always starts with)
Ethernet P1 / P2 / P3 / P4
Ethernet1 P2 / P3 / P4
Ethernet2 P3 / P4
Ethernet3 P4
Step 2: Create WAN Interface
Go to Configuration
WAN
ISP
wanlink is the factory default WAN interface which in service for data/internet access. If your ISP
uses this access protocol, click Edit to input other parameters if needed. If your ISP does not use
PPPoE, you can change the default WAN connection entry by clicking Change.
From the example, 0/40 is used for data/internet and assumes PPPoE is used; click the Edit to
change the VPI/VCI to 0/40.
Click Create to setup up additional WAN interface for video applications. Total of 8 VLAN is
support; therefore, only 8 WAN interfaces can be created in the table.
From the example, PVC 0/33 to 0/39 is assigned for video using 1483 Bridged mode. Check RFC
1483 Bridged and click Next to continue the setup.
