VCR Plus+ Channels 27
If you intend to use the VCR Plus+ programming system, program the DVD
Recorder with your local channel information.This will only take a few min-
utes. Since the channel numbers of the stations you receive may not be the
same as the station numbers, and since channel numbers differ from area to
area, you must set up channels in order for the system to work efficiently.
Before you begin, make sure you have 1) a cable TV channel list, if applicable
(you can request one from your cable TV company), and 2) a chart that lists
VCR Plus+ channel numbers, which you can find in your TV guide or the TV
listings of your local newspaper.
1
Press SYSTEM MENU. Press ; to select in the top left
corner of the menu bar at the top of the TV screen.
2
Press CH-9 repeatedly to select at the end of the next
menu screen, then press : to enter the Installation menu.
3
Press CH+8 or CH-9 to select VCR Plus+ Ch. (channel),
then press :.
4
Press CH+8 or CH-9 to select a VCR Plus+ Ch. number,
then press the Number buttons or ; or : to enter the cor-
responding Channel number from your TV guide list. If you
use the Number buttons, enter the channel number as a three-digit
number. For example, for channel 18, press 0,1,8.
Refer to the list from your local newspaper or TV guide for the VCR
Plus+ channels and corresponding TV channel numbers for your
area.These are the numbers you will enter as the Channel number
as you complete the chart on the screen.
5
Press OK to store the Channel number. “Stored” will appear
briefly in the lower left corner of the menu. Repeat steps 4-5 as
often as necessary to complete the chart.
6
When you are finished, press SYSTEM MENU repeatedly to
remove all the menus.
