32
English
Radio Reception
Tuning to radio stations
1 Press STANDBY-ONB (B on the remote)
to switch on the last selected source.
2 Press SOURCE (TUNER on the remote) to
select TUNER mode.
3 Press TUNER on the remote again to select
the desired band: FM or MW.
4 Press and hold ¡ / ™ (or 2/3 on the remote
control) until the frequency indication starts to
change, then release.
➜ The system automatically tunes to the next
strong radio station.
● To tune to a weak station, press ¡ / ™ (or 2/3
on the remote control) briefly and repeatedly
until an optimal reception is found.
5 Repeat Step 4 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 40 stations (20 in each
band) regardless of the reception.
Automatic progamming
● Press PROGRAM on the remote for more
than two seconds to activate programming.
➜ All available stations are programmed.
Manual progamming
1 Tune to your desired radio station (refer to
“Tuning to radio stations”).
2 Press PROGRAM on the remote.
➜ ”PROG” icon flashes.
Other Functions
3 Press PRESET+ or PRESET-/9 (or ¡ / ™ on
the remote) to select the desired preset number.
➜ If “PROG” icon goes off before you select the
desired preset number, press PROGRAM on
the remote.
4 Press PROGRAM on the remote again to
store the radio station.
● Repeat steps 1-4 to store other radio stations.
Listening to preset radio stations
● In tuner mode, press PRESET+ or PRESET-/
9 (or ¡ / ™ on the remote) to select the
desired preset number.
➜ The preset number, radio frequency, and
waveband are displayed.
Setting the clock
1 In Standby mode, press and hold CLOCK/RDS
on the remote until the time flashes on the
display.
➜ ”CLOCK SET” is displayed briefly. Then, the
hour digits flash on the display screen.
2 Tur n VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
hours.
3 Press CLOCK/RDS to confirm.
➜ The minute digits flash on the display screen.
4 Tur n VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
minutes.
5 Press CLOCK/RDS again to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the
system is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
pg 001-040_MCD706_98_Eng 2007.6.22, 16:3332
