15
Select a play source
On the main unit
Press the • SOURCE button repeatedly to
select: DISC > USB > FM > AUX 1 >
AUX 2 > SCART IN > DISC ...
On the remote control
Press • AUDIO SOURCE repeatedly to
switch to the connected audio source.
Display Device connected to
SCART IN SCART TO TV socket
AUX 1 AUDIO IN-AUX 1
sockets
AUX 2 AUDIO IN-AUX 2
sockets
Press • RADIO to switch to FM band.
Press • USB to switch to USB mode.
Press • DISC to switch to disc mode.
2 Press to change the volume level,
then press OK .
The test tone is emitted from the »
speaker.
Repeat the above setting for other •
speakers until all the speakers’
output level sounds equally balance.
To exit the menu, press •
SETUP .
To set the output delay time (centre and rear
speakers only)
1 Select [Speakers Delay] in the menu,
then press
.
2 Press to set the delay time, then press
OK .
Repeat the above setting for other •
speakers until the sound output from
different speakers reach the listening
position at the same time.
To exit the menu, press •
SETUP .
Tip
Set a longer delay time if the centre speaker or rear •
speaker is closer to the listening position than the
front speaker.
Allow 1ms setting for every 1 foot distance between •
the speaker and the listening position.
Speakers Distance Setup
Center
Rear Left
Rear Right
0MS
0MS
0MS
Get started
English
EN
1_hts3020-12_en2.indd Sec1:151_hts3020-12_en2.indd Sec1:15 4/2/2009 10:56:31 AM4/2/2009 10:56:31 AM
