Basic Connections (continued)
Step 2: Placing the unit
Before you start....
– Make sure that all cables have been
connected to this unit.
– To prevent this unit from being
scratched, always covers its front surface
with a cloth before you place it at on
any surface.
Option 1: Placing on the table top
A Place this unit on a at surface with the
front panel facing down.
B Place the detachable stand on the rear
panel.
C Slide the stand to the left to lock it into
position.
Option 2: Mounting on the wall
CAUTION!
Risk of personal injury and damage
to the unit. Allow only qualied
persons to mount the unit.
Note:
Mounting accessories not supplied.
A Mark the wall for screw hole positions
where you intend to mount this unit,
then drill the screw holes.
B Insert the rubber wall plugs and screws
into the holes.
C Hook this unit rmly onto the screws
and lock into position.
Helpful Hint:
– To remove the stand, press and hold the
catch at the extreme right of the rear panel
and push the panel towards the right.
To lock stand, slide to left
