12
Programming a Recording (TIMER)
Other Functions
How to check, correct or delete
a programmed recording (TIMER)
1 Press TIMER SET.
• If the DVD/VCR’s power is off,press STANDBY-ON
yy
instead of TIMER SET,then go to the next step.
2 Repeat steps 1 to 3 in the “Programming a Recording” section.
3 Select the timer block number you want to check by pressing
K/L.
• The details of the selected timer block appears on the TV
screen.
• Go to the digit you want to change by pressing s / B.Then,
enter correct numbers by pressing K/L.
• You may cancel the entire programme by pressing s while
the timer block number flashes.
4 Press MENU to exit.
5 Press TIMER SET to return to timer stand-by mode.
Hint for Timer Recording
• If there is a power failure or the DVD/VCR is unplugged for
more than 1 minute,the clock setting and all timer settings
will be lost.
• If a tape ends during TIMER RECORDING,the DVD/VCR will
stop,eject the tape,and switch to the DVD mode
automatically as ‘ ’ blinks.(If the DVD power is off,the
DVD/VCR will become the STANDBY status.)
• If a tape is not in the DVD/VCR or does not have a record
tab,‘ ’ flashes and timer recording will not operate. Please
insert a recordable tape.
• When timer recordings are set,‘ ’ will come on.To use the
DVD/VCR as usual until the time for the recording,press
TIMER SET so that ‘ ’ disappears.Press VCR to choose VCR
mode, then continue with the other features as described in
this manual.
Note:
- When all the programmed recording are finished,‘’
will flash.
This is not a malfunction.
To use the DVD/VCR,press TIMER SET to turn off ‘’.
How to use the DVD player during a VCR timer recording
or while ‘ ’ is on or flashes.
• You can use the DVD player while ‘ ’ is on or flashes,or
during a timer recording.Press STANDBY-ON
yy
to turn on
the DVD player.Press DVD on the remote control to choose
DVD mode,then continue with the other DVD features as
described in this manual.You don’t have to set the TIMER off
to use the DVD only.
How to stop timer programme already started
• Press STOP/EJECT CA on the DVD/VCR.
To avoid overlap of timer programmes
• A timer programme will not work whilst another programme
is under execution.
