20 EN
Setup
Audio setup
[Analogue Output] - Adjust this setting for audio output through AUDIO OUT.
• [Stereo] - Compress multi-channel Dolby digital sound to stereophonic sound output through
AUDIO OUT FRONT L/R.
• [LT/RT] - Compress multi-channel Dolby digital sound to 2-channel surround sound output
through AUDIO OUT FRONT L/R.
• [Multi Channel] - Enjoy Dolby digital sound output through AUDIO OUT 5.1 channels.
[Digital Audio] - Adjust this setting for audio output through COAXIAL/DIGITAL OUT.
• [Digital Output] - Select a type of digital output.
• [Off] - Disable digital output.
• [All] - Support multi-channel audio formats.
• [PCM Only] - Downmix to two-channel audio signal.
• [LPCM Output] - Select the LPCM (Linear Pulse Code Modulation) output sampling rate.
Note
•
[LPCM Output] setting is changeable only when [Digital Output] is set as [PCM Only].
The higher the sampling rate, the better the sound quality.
•
[HDMI Audio] - Enable or disable the audio output through HDMI cable.
[Audio Sync] - Set a delay time for audio output when you play a video disc.
[Volume] - Set the default volume level.
[Sound Mode] - Select a preset sound effect.
[Speaker Setup] - Optimize the surround effect for the connected speaker system.
• [Front Speaker], [Center Speaker] and [Rear Speaker]
Select • [Large] when the speakers support the output of low frequency signal (lower than
120 Hz), otherwise select [Small].
Select • [Off] to unmute the speaker(s).
• [Subwoofer] - Mute or unmute the subwoofer.
• [Speakers Volume] - Increase or decrease the volume level of each speaker.
• [Speakers Delay] - Set the delay time for each speaker.
General
Analogue Output
Digital Audio
HDMI Audio
Audio Sync
Volume
Sound Mode
Video
Audio
Preference
Stereo
Off
Night Mode
On
Speaker Setup
