15
• [Movie Mode] - Select a sound effect for
movies.
• [Music Mode] - Select a sound effect for
music.
[CD Upsampling]
For better sound quality in stereo mode, convert
the music CD to a higher sampling rate.
• [Off] - Turn off CD-upsampling.
• [88.2kHz (X2)] - Convert to twice the original
sampling rate.
• [176.4kHz(X4)] - Convert to four times the
original sampling rate.
[Night Mode]
Make loud sound level softer and soft sound level
louder so that you can watch the DVD movies at a
low volume, without disturbing others.
• [On] – Enjoy quiet viewing at night.
• [Off] – Enjoy surround sound with a full
dynamic range.
Note
Applicable only to Dolby Digital encoded DVD.•
Video setup
1 Press SETUP.
» [General Setup] menu is displayed.
2 Press to select [Video Setup], then press .
3 Select an option, then press OK.
4 Select a setting, then press OK.
To return to the previous menu, press •
.
To exit the menu, press • SETUP.
[TV System]
Change this setting if the video does not appear
correctly. By default, this setting matches the most
common setting for TVs in your country.
• [PAL] - For PAL-system TV.
• [Multi] - For TV that is compatible with both
PAL and NTSC.
1 Press SETUP.
» [General Setup] menu is displayed.
2 Press to select [Audio Setup], then press .
3 Select an option, then press OK.
4 Select a setting, then press OK.
To return to the previous menu, press •
.
To exit the menu, press • SETUP.
[Analogue Output]
Select an analogue setting based on the audio
device that is connected through the analogue
audio jack.
• [Stereo] - For stereo output.
• [LT/RT] - For surround sound output through
two speakers.
[Digital Audio]
Select a digital setting based on the digital amplifi er/
receiver that is connected through the digital jack
(coaxial/digital).
• [Digital Output] - Select a type of digital
output.
• [Off] - Disable digital output.
• [All] - Support multi-channel audio
formats.
• [PCM Only] - Downmix to two-channel
audio format.
• [LPCM Output] - Select the LPCM (Linear
Pulse Code Modulation) output sampling rate.
• [48kHz] - For discs recorded at sampling
rate of 48 kHz.
• [96kHz] - For discs recorded at sampling
rate of 96 kHz.
Note
• [LPCM Output] setting is only available if the [Digital
Output] is set to [PCM Only].
The higher the sampling rate, the better the sound
•
quality.
[Volume]
Set the default volume level when you play a disc.
1. Press OK.
2. Press
to set the volume.
3. Press OK to confi rm and exit.
[Sound Mode]
Select a preset sound effect to enhance the audio
output.
• [3D] - Select a virtual surround sound effect
that is produced from the left and right audio
channels.
English
EN
