Mechanical Instructions
Rear Cover Removal
1. Removeall fixation screws of the rear cover.
2. Now pull the rear cover backward to remove it.
Service Position Main Panel
There are 2 configurations. With and withoutpanel bracket. Both have a different service
position:
Main panel without bracket.
1. Disconnectthe strain relief of the AC power cord.
2. Remove the main panel, by pushing the two centerclips outward [1]. At the same time
pull the panelaway from the CRT [2].
3. Disconnect the degaussing coil by removing thecable from (red) connector 0201.
4. Turn the panel 90 degrees counter clockwise [3].
5. Flip the panel 90 degrees [4],with the components towards the CRT.
6. Turn the panel with the rear I/O towardsthe CRT [5].
7. Slide the metal heatsink (near the mains transformer5520) underneath the right chassis
bracket, so the panel is secured [6].
Pa
e 1 of 7SPMS
7/8/2004
