Special safety precaution and disclaimer for medical model (200P4MG only)
● Intended for medical electrical equipment purpose (200P4MG)
● The monitor shall not be operated in the presence of defibrillation equipment (200P4MG).
● This equipment is a source of electromagnetic interference. Before use please, make
sure that it does not impair the safe performance of any equipment located in its vicinity
(200P4MG).
● The EMC test of this monitor is evaluated according to EN/IEC 60601-1 (200P4MG).
● The medical approved 200P4MG shall always connect to other IEC 60601-1 approved
equipments.
● This equipment is suitable for continuous operation.
● This equipment is classified as Class I regarding the protection against electric shock.
● This equipment does not have applied parts.
● This equipment has a degree of protection against ingress of water IPX0.
● This equipment is not suitable for use in a presence of flammable anesthetic mixture with
air or with oxygen or nitrous oxide.
Consult a service technician if the monitor does not operate normally when the operating
instructions given in this manual have been followed.
RETURN TO TOP OF THE PAGE
Installation Locations
● Avoid exposure to heat and extreme cold.
● Do not store or use the LCD monitor in locations exposed to heat, direct sunlight or
extreme cold.
● Avoid moving the LCD monitor between locations with large temperature differences.
Choose a site that falls within the following temperature and humidity ranges.
❍ Temperature: 5-35°C 41-95°F
❍ Humidity: 20-80% RH
● Do not subject the LCD monitor to severe vibration or high impact conditions. Do not
place the LCD monitor in the trunk of a car.
● Take care not to mishandle this product by either knocking or dropping it during operation
or transportation.
● Do not store or use the LCD monitor in locations where there is a high level of humidity
or in dusty environments. Do not allow water or other liquids to spill on or into the LCD
monitor.
RETURN TO TOP OF THE PAGE
file:///D|/My%20documents/dfu/J/english/200p4/safety/safety.htm (2 of 2)7/9/2004 12:35:52 PM
