A SERVICE OF

logo

Testing
5-4
7986-A2-GB20-10
December 1998
Repeater Loopback
Repeater Loopback (RLB) loops the signal being sent from the data port back to
the data port and to the network interface.
CAP
DSL
Port
G.703
Port
CAP E1
LIU
FramerFramerTransceiver
98-15999
" Procedure
To run a Repeater Loopback:
1. Position the cursor at the Start command next to Repeater Loopback on the
Network Tests screen.
2. Press Enter.
The Start command is changed to Stop.
3. To manually stop the test, verify that the cursor is positioned at the Stop
command.
4. Press Enter.
A Repeater loopback cannot be started when any other loopback test is in
progress.
NOTE:
Activating the Repeater Loopback test causes the EOC to be lost to the
remote unit.