A SERVICE OF

logo

Open as PDF
next previous
10
7511-A2-GN10-10
January 1999
495-14797
3. Slide the circuit card into the slot and press until the connectors are seated
firmly into the back of the carrier.
4. If power is applied to the carrier:
— All LEDs on the card light up momentarily.
— The card completes its power-up self-test.
— The Alarm and OK LEDs are turned off or on depending on the test
results.
5. Press the faceplate latch to secure the circuit card.
6. Rotate the circuit pack lock into the closed position, and tighten the screw.
7. Return to the rear of the carrier and tighten the screw on the rear connector
plate.