Paradyne 3151 CSU Manual

A SERVICE OF

next previous

10

Table 6. General Management Configuration Options (1 of 2)

Option Factory 1 Factory 2 Comments/Description

SNMP Mgt:

Disab Disab

Specifies whether the DSU/CSU

responds to SNMP session

SNMP Mgt:

Enab Enab

p

responds to SNMP session

requests.

NMS Valid:

Disab Disab

Specifies whether the DSU/CSU

validates the IP address of an

NMS Valid:

Enab Enab

validates

the

IP

address

of

an

SNMP manager attempting

access.

Num Sec Mgrs:

1 1

The number of SNMP managers

Num Sec Mgrs:

2–10 2–10

The

number

of

SNMP

managers

allowed to access the DSU/CSU.

NMS

n

IP Adr:

Edit Edit

Allows you to define or clear the

allowable IP address of an SNMP

NMS

n

IP Adr:

Clear Clear

y

allowable IP address of an SNMP

manager.

NMS

n

Access:

Read Read

The type of access allowed for an

SNMP managerusing community

NMS

n

Access:

R/W R/W

yp

SNMP manager using community

name 1.

System Name:

Edit Edit

The SNMP system name for this

System Name:

Clear Clear

The

SNMP

system

name

for

this

device.

System Location:

Edit Edit

The SNMP system location for this

System Location:

Clear Clear

The

SNMP

system

location

for

this

device.

System Contact:

Edit Edit

The SNMP system contact name

System Contact:

Clear Clear

The

SNMP

system

contact

name

for this device.

CommunityName1:

Edit Edit

A community name that is allowed

access to this device Defaults to

CommunityName1:

Clear Clear

y

access to this device. Defaults to

public

.

Access 1:

Read Read

The type of access allowed for

Access 1:

R/W R/W

The

type

of

access

allowed

for

community name 1.

CommunityName2:

Edit Edit

A community name that is allowed

CommunityName2:

Clear Clear

A

community

name

that

is

allowed

access to this device.

Access 2:

Read Read

The type of access allowed for

Access 2:

R/W R/W

The

type

of

access

allowed

for

community name 2.

IP Adr:

Edit Edit

The IP address needed to access

IP Adr:

Clear Clear

The

IP

address

needed

to

access

the device.

NetMask:

Edit Edit

The Subnet Mask needed to

NetMask:

Clear Clear

The

Subnet

Mask

needed

to

access the device.

Com IP Adr:

Edit Edit

The IP address for the COM port

Com IP Adr:

Clear Clear

The

IP

address

for

the

COM

port

when configured for SNMP.