A SERVICE OF

logo

Open as PDF
next previous
12
STEP 10:
• Securely tighten the SPRING PIN (50) to the FRAME (1) and hand tighten the THREE PRONG KNOB (52)
• Apply four PARAGLIDES (58) to the INSIDE of the tube of FRAME (1) as shown. Apply the remaining four
PARAGLIDES (58) to the OUTSIDE and FLUSH TO BOTTOM of tube located on SEAT ADJUSTMENT (10)
• Securely assemble one SEAT PAD (13) to the SEAT ADJUSTMENT (10) using two 3/8 X 2-3/4” BOLTS (28) and two
3/8” WASHERS (36) as shown.
FIGURE 10
• Securely assemble one SEAT PAD (13) to the FRAME (1) using two 3/8 X 2-3/4” BOLTS (28) and two 3/8” WASHERS (36)
as shown.
• Gently insert SEAT ADJUSTMENT (10) into tube located on FRAME (1)
DO NOT FORCE THE SEAT ADJUSTMENT IN. THIS MAY CAUSE THE PARAGLIDES TO TEAR.
• Apply WEIGHT STACK LABELS (61) to WEIGHTS (22) and HEAD PLATE (19) as shown in FIGURE 10.
Begin with number one at the HEAD PLATE (19) with larger numbers in consecutive order towards bottom of weight stack.
1
28
36
13
52
50
10
58
3/8 X 2-3/4”
61
19
22