➢
When the bristles on the agitator are
so worn that they do not touch a card
held across the lower plate, the
brushes should be replaced.
➢
Remove lower plate and agitator.
➢
Remove the E-clip from agitator shaft
and end cap.
➢
Do not bend agitator shaft or lose E-
clip.
➢
Pull agitator shaft out of agitator
body.
➢
Pull, or pry out, agitator holder and
belt pulley.
➢
Push each brush out of agitator body
as shown.
➢
Install new brushes by reversing
procedure.
➢
Reinstall agitator holder and agitator
pulley completely.
➢
Reinstall the agitator shaft, end cap
and E-clip.
➢
See enlarged view for correct
assembly of parts (page 38).
➢
Position belt over belt pulley on the
agitator.
➢
Reinstall agitator and lower plate.
- 36 -
