Preparation
11
Battery level
Panasonic Ni-MH battery
performance (supplied batteries)
Note:
L It is normal for batteries not to reach
full capacity at the initial charge.
Maximum battery performance is
reached after a few complete cycles of
charge/discharge (use).
L To maximize battery life, it is
recommended that the handset
batteries be fully discharged (used)
until 7 flashes once every few
months.
L Actual battery performance depends
on a combination of how often the
handset is in use and how often it is
not in use (standby).
L The battery level may not be
displayed correctly after you replace
the batteries. In this case, place the
handset on the base unit or charger
and let it charge for at least 7 hours.
Turning the power
on/off
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.
Setting up the unit
before use
Display language
1
{ih} i {j/OK}
2 Press {^} or {V} to select “Handset
Setup”. i {>}
3 Press {^} or {V} to select “Display
Setup”. i {>}
4 Press {^} or {V} to select “Select
Language”. i {>}
5 Press {^} or {V} to select the
desired language. i {>} i
{ih}
Note:
L If you select a language you cannot
read: {ih} i {j/OK} i {^} 3
times i {>} i {V} 2 times i
{>} 2 times i {^}/{V}: Select the
desired language. i {>} i
{ih}
Battery icon Battery level
5 High
6 Medium
7 Low
L When flashing:
Needs to be
charged.
Operation Operating
time
In continuous use 17 hours max.
In continuous
standby mode
180 hours
max.
TG7200-7220HK(e-e).book Page 11 Tuesday, September 4, 2007 9:29 AM
