E
N
G
L
I
S
H
3
Clock Setting
Audio Modes
(Bass/Treble/Balance/Fader)
The 24-hour system is used for the clock.
q
Push [SEL] to select the audio mode.
[
kk
TUNE], [
ll
TUNE] (Hours, minutes)
w
Turn [VOL] clockwise or counterclockwise to
change each level.
Hours
w Press and hold [DISP] (display) for more than 2
seconds.
Bass:
Adjustable range: –12 to +12 dB (by 2 dB step)
Treble:
Adjustable range: –12 to +12 dB (by 2 dB step)
Balance:
Adjustable range:
1 to 15 (by 1 step)
Balance center
(default)
R (right speaker) or L (left speaker)
Fader:
Adjustable range: 1 to 15
(by 1 step)
Fader center
(default)
F (front speaker) or R (rear speaker)
Initial Time
q Press [DISP] (display).
(Hours blink.)
e Press [
kk
TUNE] or [
ll
TUNE].
(Hours set.)
Minutes
r Press [DISP] (display).
(Minutes blink.)
t Press [
kk
TUNE] or [
ll
TUNE].
(Minutes set.)
y Press [DISP] (display).
Note: Press and hold [
kk
TUNE] or [
ll
TUNE] to
change numbers rapidly.
Time Reset
Press and hold [DISP] (display) for more than
2 seconds to activate the time setting mode to reset
the time.
Then, repeat steps
e to y.
(End.)
(Clock display)
Note: If no operation takes place for more than 5 seconds
in audio mode (2 seconds in volume mode), the display
returns to the regular mode.
push
“AdJ” is displayed when the clock is not adjusted.
Volume
Turn the knob clockwise to increase volume,
and counterclockwise to decrease volume.
Mute
Press [MUTE] to mute the sound completely.
Loudness
Press and hold for more than 2 seconds. [MUTE]
(LOUD) to enhance bass and treble tones at low or
medium volume.
Loudness indicator
Press and hold for more than 2 seconds
[MUTE]
(LOUD) again to cancel.
Up
Down
Press [MUTE] again to cancel.
MUTE indicator
[DISP] (display)
E
N
G
L
I
S
H
2
default: 0 dB
default: 0 dB
