10 51-3849, 5/26/06
Safety Signs and Labels
There are several specific safety signs on this sweeper. The
exact location of the hazards and the description of the
hazards are reviewed in this section.
SAFETY SECTION
SAFETY SIGNS & LABELS
Item Part Qty Description
2. 50-0634 1 Label, Serial Number
3. 50-0643 2 Label, Tie Down Point
4. 50-0721 2 Label, Warning, Crush Hazard
5. 50-0722 1 Label, Warning, Misuse Hazard
6. 50-0725 1 Label, Warning, High Pressure Fluid Hazard
7. 50-0726 2 Label, Warning, Flying Objects & Entanglement
Placement or Replacement of Safety Signs
1. Clean the area of application with nonflammable solvent,
and then wash the same area with soap and water.
2. Allow the surface to fully dry.
3. Remove the backing from the safety sign, exposing the
adhesive surface.
4. Apply the safety sign to the position shown in the diagram
above and smooth out any bubbles.
Instructions
• Keep all safety signs clean and legible.
• Replace all missing, illegible, or damaged safety
signs.
• Replacement parts, for parts with safety signs
attached, must also have safety signs attached.
• Safety signs are available, free of charge, from your
dealer or from SWEEPSTER.
