27
Connecting the Power
• Before you plug in the TX-NR801/TX-NR801E, con-
firm that all connections have been made properly.
• Turning on the power may cause a momentary power
surge, which might interfere with other electrical
equipment on the same circuit, such as computers. If
this happens, use a wall outlet on a different circuit.
(All models other than USA, Canadian and Austra-
lian models)
• The TX-NR801/TX-NR801E is shipped with the
main power (POWER) switch in the on position
( ). When the power cord is plugged in for the
first time, the TX-NR801/TX-NR801E will automati-
cally enter the standby state and the STANDBY indi-
cator will light (same condition after step 2 below).
Before you can use the remote controller, you must
perform steps 1 and 2 above and place the TX-NR801/
TX
-
NR801E in the standby state.
Memory backup
The TX-NR801/TX-NR801E uses a battery-less mem-
ory backup system in order to retain radio presets and
other settings when it is unplugged or in the case of a
power failure. Although no batteries are required, the
TX-NR801/TX-NR801E must be plugged into an AC
outlet in order to charge the backup system.
(On other than USA, Canadian and Australian models,
the TX-NR801/TX-NR801E’s POWER switch must be
set to ON in order to charge the backup system.) Once it
has been charged, the TX-NR801/TX-NR801E will
retain the settings for several weeks, although this
depends on the environment and time will be shorter in
humid climates.
DSP
A
-
FO
RM LISTENING MODE MEMORY
THX
SURROUNDDIRECT
/
PURE AUDIOSTEREO
FM
MODE
MEMORY
ENTER
RE
TURN
SETUP
TUNING
PRESET
DSP
A
-
FO
RM LISTENING MODE MEMORY
THX
SURROUNDDIRECT
/
PURE AUDIOSTEREO
FM
MODE
MEMORY
ENTER
RE
TURN
SETUP
TUNING
PRESET
ON
RCVR
STANDBY
STANDBY/ON STANDBY/ON
POWER
(USA, Canadian and Australian models)
(Other models)
STANDBY indicator STANDBY indicator
To wall outlet
To wall outlet
Turning on the Power
1
Plug the power cord into an AC
wall outlet.
(USA, Canadian and Australian
models)
The STANDBY indicator will light up.
(Other models)
Press the POWER switch to set the
TX-NR801/TX-NR801E to standby
state.
The STANDBY indicator will light up.
2
Press the STANDBY/ON button to
turn on the TX-NR801/TX-NR801E.
The display will light up and the
STANDBY indicator will turn off.
If you press the STANDBY/ON button
again, the TX-NR801/TX-NR801E
returns to the standby state.
ON
STANDBY
OFF
ON
POWER
STANDBY
STANDBY/ON
STANDBY
Turn off
Turning on the Power from the
Remote Controller
1
Press the RCVR MODE button.
The RCVR MODE button lights.
2
Press the ON button to turn on the
TX-NR801/TX-NR801E (take it out
of the standby state).
To return the TX-NR801/TX-NR801E
to the standby state, press the
STANDBY button.
