56
Troubleshooting—Continued
Interactive control with other Onkyo -capable components is not working.
• Make sure the cables and analog audio cables are connected correctly (see pages 20 to 22). Connecting only an
cable won’t work.
• Make sure the Input Display matches the type of device that you’ve connected to the CD receiver (see page 26).
No sound is heard from a connected component.
• Make sure the correct input source is selected (see page 24).
• Make sure the analog audio cable is connected correctly (see pages 20 to 22).
• Make sure that all audio connecting plugs are pushed in all the way (see page 19).
No sound is heard from your turntable.
• Make sure the turntable has a built-in phono equalizer.
• If the turntable doesn’t have a phono equalizer built-in, you must provide one.
Timer playback or recording doesn’t work.
• Make sure the clock has been set correctly (see pages 47, 48).
• Timed operation will fail if the CD receiver is on at the specified On time, so make sure it’s set to Standby (see
page 51).
• The timer may overlap with another timer. If you program several timers, make sure they don’t overlap (see page 49).
• If you press the [SLEEP] or [TIMER] button while a timed operation is in progress, the timer will be cancelled.
• Make sure the cables and analog audio cables are connected correctly (see pages 20 to 22).
• If you’re using an Onkyo component for timed playback or recording, you must set the Input Display to match that
component (see page 26).
The time is not displayed in Standby mode.
• Set the CD receiver so that the time is displayed in Standby mode (see page 48).
External Components
Timers
Clock
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s
malfunction. Before you record important data, make sure that the material will be recorded correctly.
The CD receiver contains a microcomputer for signal processing and control functions. In very rare situations, severe
interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this
should happen, unplug the power cord, wait at least 5 seconds, and then plug it again.
