2
SAFETY and GENERAL INFORMATION
Save these instructions. For your safety, read, understand, and follow the information provided with and on this
jack before using. The owner and/or operator of this equipment shall have an understanding of this jack and safe
operating procedures before attempting to use. The owner and/or operator shall be aware that the use and repair of
this product may require special skills and knowledge. Instructions and safety information shall be conveyed in the
operator’s native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of
this jack, remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked, or damaged parts (including labels) are noted. Any
jack that appears damaged in any way, operates abnormally or is missing parts, shall be removed from service
immediately and the manufacturer notied. If you suspect that the jack was subjected to a shock load (a load dropped
suddenly, unexpectedly upon it), immediately discontinue use until jack has been checked by a factory authorized
service center (contact distributor or manufacturer for list of Authorized Service Centers). It is recommended that an
annual inspection be done by qualied personnel. Labels and owner’s manuals are available from manufacturer.
PRODUCT DESCRIPTION
The Omega MagicLift™ Low Prole Service Jack is designed to lift, but not support, one end of a vehicle. This jack
must be used in conjunction with a pair of appropriately rated jack stands. Each MagicLift™ Service Jack has a
unique feature, which provides fast, no load lifts to the jacking point, at which time it lifts in approximately 0.75~2"
increments.
Model Capacity Jack Size (L x W x H) Min. Height Max. Height
29023 2 Ton 42-1/2" x 13-3/4" x 6-3/4"
2-1/2"
20"
29025 2 Ton 30" x 13-5/8" x 5-5/8" 19-5/8"
!
NEVER use a hydraulic jack as a stand-alone device. After lifting, immediately support the lifted vehicle with
a pair of appropriately rated jack stands. NEVER place any portion of your body beneath the vehicle when
lifting OR lowering!
SPECIFICATIONS
Figure 1 - Model 29023 Nomenclature
saddle
lift arm
handle
handle sleeve
rear caster
Vent screw
(under cover plate,
on reservoir)
front wheel
