26
Inspect and properly tighten all parts of the exercise
cycle regularly. To clean the exercise cycle, use a
soft, damp cloth. Keep liquids away from the console
and keep the console out of direct sunlight.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted. To
adjust the drive belt, you must first remove the right
side shield. First, remove the indicated M4 x 25mm
Screws (65) from the Left Side Shield (26).
Next, remove the indicated M5 x 25mm Screw (37)
and M4 x 16mm Screws (57) from the Right Side
Shield (27). Using an adjustable wrench, turn the
Right Pedal (21) counterclockwise and remove it. Turn
the Right Crank Arm (23) so that it is pointing toward
the front of the exercise cycle, and then slide off the
Right Side Shield.
Next, turn the indicated M8 Nylon Locknut (31) until
the Drive Belt (47) is properly tightened. Then, reattach
the right side shield.
PULSE SENSOR TROUBLESHOOTING
If the chest pulse sensor does not function properly,
see CHEST PULSE SENSOR TROUBLESHOOTING
on pages 9 and 10. If the handgrip pulse sensor does
not function properly, see step 5 on page 14.
MAINTENANCE AND TROUBLESHOOTING
57
21
23
27
47
37
57
65
26
65
31
