WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
13-10 Configuring Management Utilities
v1.0, June 2007
Access Point/Air Monitor Traps
Table 13-6 lists the key traps generated by an access point or an air monitor,
Authentication ACL table
full
The maximum number of ACL entries in the ACL table has
been exceeded. The limit is 2048 entries on a WFS709TP.
High
Power supply failure One of the two possible power supplies in the WFS709TP has
failed.
Critical
Fan failure The fan in the WFS709TP has failed. Critical
Out of Range Voltage An out-of-range voltage is being supplied to the WFS709TP. Critical
Out of Range
temperature
An out-of-range operating temperature being supplied to the
WFS709TP.
Critical
Line card inserted/
removed
A Line Card has been inserted or removed from the
WFS709TP.
Critical
Supervisor card inserted/
removed
A Supervisor card has been inserted or removed from the
WFS709TP.
Critical
Power supply missing One of the power supplies is missing. Critical
Table 13-6. Access Point SNMP Traps
Trap Description Priority Level
Unsecure AP detected An AM has detected and classified an AP as unsecure. This
trap will indicate the location of the AM that has detected the
unsecure AP, the channel on which the AP was detected, and
the BSSID and SSID of the detected AP.
Critical
Station impersonation An AM has detected a Station impersonation event. The trap
will provide the location of the AM that has detected the event
and the MAC address of the Station.
Critical
Reserved channel
impersonation
An AP is being detected is violating the Reserved Channels.
This trap will indicate the location of the AP or AM that detects
the event, and the BSSID and SSID of the detected AP.
High
Valid SSID violation This trap indicates a violation in the configuration of the SSID
of the AP. The AP generates the trap and includes its BSSID,
the configured SSID, and the location of the AP in the trap.
High
Channel misconfiguration This trap indicates an error in channel configuration of an AP.
The AP generates the trap and includes its BSSID, the
configured SSID, and the location of the AP in the trap.
High
Table 13-5. WFS709TP SNMP Traps (continued)
Trap Description Priority Level
