A SERVICE OF

logo

12 2. CABLE CONNECTION
2. CABLE CONNECTION
2-1. Before Connecting
Following 4 resolutions
p.27)
with frequency can be displayed on this model. The lower
display modes like 640 x 480 or 720 x 400 mode, automatically enlarge to the maximum
display mode (1024 x 768). In this case, some lines of the characters may become fuzzy.
Use Smoothing function to make the lines clear (see page 18).
2-2. Connecting the Signal Cable
Be sure that the power switches of both the PC and the monitor are OFF.
1. Plug the signal cable into the DVI-D connector at the rear of the
monitor and the other end of the cable into the digital video connector
on the PC.
After connecting, secure the connection with the screw-in fasteners.
2. Plug the power cord into the power connector on the rear of the
monitor. Plug the other end of the power cord into a power outlet.
noituloseR ycneuqerF skrameR
084x046zH06AGV
004x027zH07txeTAGV
006x008zH06ASEV
867x4201zH06ASEV
Video output connector
DVI-D
FD-C04 (attached)
Digital
Graphics board