7. ATTACHING AN ARN STAND 37
ENGLISH
7. ATTACHING AN ARM STAND
The LCD monitor can be used with an arm stand by removing the tilt stand and
attaching the arm stand to the LCD monitor.
NOTE
´ Use an arm stand that satisfies the followings.
• When using the LCD monitor with an arm stand, the
arm stand must be VESA approved :
* Use an arm stand with a 100 mm x 100 mm hole
spacing on the arm mounting pad.
* Use an arm stand that is able to support an
object weighing 13.5 kg.
´ TÜV/GS approved arm stand.
´ Use an arm stand with sufficient stability
(mechanical firmness) to support the weight of the
monitor.
´ Use an arm stand remaining that position where it is
manually moved.
´ Use an arm stand with the ability to tilt the monitor
forward and backward.
´ Please connect cables after attaching an arm stand.
Setup Procedure
1. Lay the LCD monitor down. Do not scratch the panel.
2. Remove the stand by loosening the screws. (4 pcs of M4 x 16 Ni/Fe)
M4 x 16 mm x 4
100 mm
100 mm
