FCC Declaration of Conformity
We, the Responsible Party EIZO NANAO TECHNOLOGIES INC.
5710 Warland Drive, Cypress, CA 90630
Phone: (562) 431-5011
declare that the product Trade name: EIZO
Model: FlexScan F931
is in conformity with Part 15 of the FCC Rules. Operation of this product is subject tois in conformity with Part 15 of the FCC Rules. Operation of this product is subject to
is in conformity with Part 15 of the FCC Rules. Operation of this product is subject tois in conformity with Part 15 of the FCC Rules. Operation of this product is subject to
is in conformity with Part 15 of the FCC Rules. Operation of this product is subject to
the following two conditions: (1) this device may not cause harmful interference, andthe following two conditions: (1) this device may not cause harmful interference, and
the following two conditions: (1) this device may not cause harmful interference, andthe following two conditions: (1) this device may not cause harmful interference, and
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may(2) this device must accept any interference received, including interference that may
(2) this device must accept any interference received, including interference that may(2) this device must accept any interference received, including interference that may
(2) this device must accept any interference received, including interference that may
cause undesired operation.cause undesired operation.
cause undesired operation.cause undesired operation.
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provid reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.
*Reorient or relocate the receiving antenna.
*Increase the separation between the equipment and receiver.
*Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
*Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note
Use the attached specified cable below or EIZO signal cable with this monitor so as to
keep interference within the limits of a Class B digital device.
-AC Cord
-Shielded Signal Cable (enclosed)
Canadian Notice
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de le classe B est comforme à la norme NMB-003 du Canada.
For U.S.A, Canada, etc. (rated 100-120 Vac) Only
