English
10 2. CONNECTING THE eClient
2. CONNECTING THE eClient
This chapter shows how to connect the eClient to a WTS.
2-1. Setting up the eClient
Please observe the following cautions when connecting the eClient.
WARNING
Place the eClient on a strong, stable surface.
A unit placed on an inadequate surface may fall, resulting in injury
or equipment damage. If the unit falls, disconnect the power
immediately and have the unit checked by a qualified service
engineer before using it again. Using a unit after it has been
dropped may result in fire or electric shock.
Set the unit in an appropriate location.
* Do not install in a dusty or humid environment.
* Do not place in a location where steam can have direct contact
with the screen.
* Do not place near heat generating devices or a humidifier.
