12
E
4. Operation
4.8. Using the timer
2) Set the time to start the unit as follows
1 Press
button to display B
.
2 Press
button to set the time that you want the unit to start.
The start time is displayed at A.
3) Set the time to stop the unit as follows
1 Press
button to display C
.
2 Press
button to set the time that you want the unit to stop.
The stop time is displayed at A.
4) Changing the set times
1 Press
button to display the time (CURRENT, START,
STOP) you want to change.
2 Press
button to set the desired time.
• When change is made to either one of a pair, e.g., AUTO START or
AUTO STOP, set the time you need not to change to . This
display is available following 23:50.
4.8. Using the timer
5) AUTO START and AUTO STOP operation
1 Press
button to make the following checks.
Check that the current time is correct.
Check that the automatic start time is correct.
Check that the automatic shutdown time is correct.
• For selection or changing of time, see the previous page
(page 11)
.
• The next operation time is displayed after approximately 10 seconds.
3 Press button to display A on the remote controller.
• Each time you press button, available options change as follows
with relative displays on the remote controller.
Remote controller display — ↔ A
Available setting — Timer-interlocked operation
ON OFFCLOCK
FILTER
CHECK
TEST RUN
REMOTE CONTROLLER
PAR-JH240KA
TEMP. TIMER SET
ON/OFF
–
STAND BY
DEFROST
CENTRALLY CONTROLLED
˚C
CLOCK
ON OFF
˚C
1Hr.
NOT AVAILABLE
CHECK MODE
FILTER
CHECK
TEST RUN
A
3 1
ON OFFCLOCK
FILTER
CHECK
TEST RUN
REMOTE CONTROLLER
PAR-JH240KA
TEMP. TIMER SET
ON/OFF
–
STAND BY
DEFROST
CENTRALLY CONTROLLED
˚C
CLOCK
ON OFF
˚C
1Hr.
NOT AVAILABLE
CHECK MODE
FILTER
CHECK
TEST RUN
1
2
CBA
