14
CAUTION: It is important to prevent
gum deposits from forming in essential fuel
system parts such as thecarburetor, fuelfil-
ter, fuel hose, or fueltank duringstorage. Al-
cohol blendedfuels (calledgasohol or using
ethanol or methanol) can attract moisture
which leads to fuel mixture separation and
formationofacidsduringstorage. Acidicgas
can damage the engine.
TROUBLE CAUSE REMEDY
Engine will not
start or will run
only a f ew
seconds after
starting.
1. Ignition switch off.
2. Engine flooded.
3. Fuel tank empty .
4. Spark plug not firing.
5. Fuel not reaching
carburetor .
1. Move ignition switch to ON.
2. See “Dif ficult Starting” in
Operation Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
Engine will
not idle
properly.
1. Idle speed requires
adjustment.
2. Carburetor requires
adjustment.
1. See “Carburetor Adjustment” in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
1. Air filter dirty.
2. Spark plug fouled.
3. Chain brake engaged.
4. Carburetor requires
adjustment.
Engine will not
accelerate,
lacks power,
or dies under
a load.
1. Clean or replace air filter.
2. Clean or replace plug and regap.
3. Disengage chain brake.
4. Contact an authorized service dealer.
Engine
smokes
excessively.
1. Too much oil mixed with
gasoline.
1. Empty fuel tank and refill with
correct fuel mixture.
WARNING: Always stop unit and disconnect spark plug before performing all of
therecommendedremediesbelow exceptremediesthatrequireoperationoftheunit.
TROUBLESHOOTING TABLE
Chain moves
at idle speed.
1. Idle speed requires
adjustment.
2. Clutch requires repair.
1. See “Carburetor Adjustment” in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
DECLARATION OF CONFORMITY
EC Declaration of Conformity (Only applies to Europe)
We, Husqvarna Outdoor Products Italia, S.p.A., Valmadrera, Italy . Tel:
+39--0341--203211, declare that the chain saw models McCulloch Mac 316 XT CSI--- AV
fromserial numbers2007--151(NorD) 00001andonwards(theyearis clearlystatedonthe
ratingplate,followedbytheserialnumber),complywiththerequirementsoftheCO UNCIL’S
DIRECTIVES:
of 22 June 199 8 “relating to machinery” 98/37/EC, annex IIA;
of 3 May 1989 “relating to electromagnetic compatibility” 89/336/EEC, and applicable
supplements; and
of8May2000“relatingtothenoiseemissions intheenvironment”inaccordancewithAnnex
Vof2000/14/EC. The measured sound power is 110 dB(A), the guaranteed sound power
is 118 dB(A) and the net power is 1,0 kW.
The following standards have been applied: ISO 11681--1:2004, EN/ISO 12100--1:2003,
EN/ISO 12100--2:2003, and CISPR 12:2001.
Notifiedbody,0404 the SwedishMachineryT estingInstitute,Fyrisborgsgatan 3S--754
50 Uppsala, Sweden, has carried out EC type approval. The certificate(s) is numbered:
404/07/1193.
The supplied Chain Saw conforms with the sample that un derwent the EC type approval.
07--05--31
Michael S. Bounds, Director
Product Safety and Standards
Handheld Consumer Products
