ASSEMBLING AND ADJUSTMENTS
6 – English
General
Handle
Assembly
Top handle
Place the handlebar’s tubular construction in direct
opposite to the lower part of the handlebar. Tighten the
knobs properly.
Settings
Handle height
• Loosen the lower knobs.
• Adjust the height. Tighten the knobs properly.
Cutting height
Move the lever to the back for higher cutting height and to
the front for lower cutting height.
Catcher
• Fit the catcher bag.
• Attach the hooks in the upper edge of the chassis.
• Fit the bagger bottom in the discharge hole.
Mulcher insert
• Raise the discharge guard to mount / dismount the
mulch plug.
Hook the spring in the frame.
Filling with oil
• The oil tank is empty at delivery. Fill the oil slowly. See
instructions under the heading Maintenance. The
engine oil should be changed the first time after 5
hours running time.
!
IMPORTANT! Prevent unintentional
starting by removing the ignition cable
from the spark plug.
NOTICE! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
