Settings | Control Panel Options 111
E-EQ-MX7RG-B MX7 Reference Guide
Main Tab
Access: | Settings | Control Panel | Scanner | Main tab
Factory Default Settings
Main
Port 1 Internal
Port 2 Disabled
Port 3 Disabled
Send key messages (WEDGE) Enabled
Enable Internal Scanner Sound Enabled
Good Scan Vibration Disabled / Long
Bad Scan Vibration Disabled / Long
Figure 3-26 Scanner Panel - Main
Adjust the settings and tap the OK box to save the changes. The changes take effect immediately.
Bluetooth is not supported by LXE.
Parameter Function
Port Port 1 – Internal. Radio button allows scanner input/output on Port 1
(scan key or trigger).
Port 2 – Output is enabled when COM1 is enabled on this port.
Port 3 - Output is enabled when COM1 is enabled on this port.
Send Key Messages
(WEDGE)
The default setting is Enabled. This feature coexists with the
Prefix/Suffix feature and the Advanced Control Character Mapping
feature. Enable for Key Message mode, disable for Block Mode.
Enable to use Advanced Control Character Mapping.
Enable Internal Scanner
Sound
The default is Enabled. Functionality of the internal scanner driver
engine includes audible tones on good scan (at the maximum db
supported by the speaker), failed scan, and LED indication of a scan
in progress. If enabled, Good Scan / Bad Scan Vibration provides a
tactile response on a scan event.
Disable this parameter when good scan/bad scan sounds are to be
handled by alternate means e.g. application-controlled sound files.
