10
Configuration Using the Console Interface
24-Port 10/100 + 4-Port Gigabit Switch with WebView and Power over Ethernet
Chapter 4
You can add up to five user accounts in addition to the
default admin account. The admin account cannot be
deleted from the system.
To save the new user account information, use the arrow
keys to select Save and press Enter.
IP Configuration
The IP Configuration screen displays four menu choices:
IP Address Settings, HTTP/HTTPS, SNMP, and Network
Diagnostics.
IP Configuration
IP Address Settings
The IP Address Settings screen allows you to set the IP
information for the Switch.
IP Address Configuration
IP Address This sets the Switch’s IP Address. The default
setting is 192.168.1.5.
Subnet Mask This combined with the IP Address defines
the Switch’s network address.
Default Gateway This defines the IP Address for the
default gateway of the network.
Management VLAN Set the ID number of the
Management VLAN. This is the only VLAN through which
you can gain management access to the Switch. By
default, all ports on the Switch are members of VLAN 1,
so a management station can be connected to any port
on the Switch. However, if other VLANs are configured
and you change the Management VLAN, you may lose
management access to the Switch. In this case, you should
reconnect the management station to a port that is a
member of the Management VLAN.
WARNING: Do not define the Management
VLAN as a VLAN that has yet to be created. If
the VLAN does not exist already, the software
will automatically create the VLAN but will not
assign VLAN membership. If this happens, the
Switch cannot be managed via the web-based
utility until it has been reconfigured via the
console interface.
IP Mode Choose to have either a user-defined IP address
or to have it assigned by DHCP or BOOTP.
HTTP/HTTPS
The HTTP/HTTPS screen allows you to set the Hyper Text
Transfer Protocol server (web server) information for the
Switch.
HTTP/HTTPS
HTTP Server Enable or disable the Switch’s HTTP server
function.
HTTP Server port Set the TCP port that HTTP packets are
sent and received from.
HTTPS Server Enable or disable the Secure HTTP server
function of the Switch.
HTTPS Server port Set the TCP port that the HTTPS
packets are sent and received from.
SNMP
The SNMP screen allows you to set the Switch’s SNMP
settings.
