EtherFast
®
Cable/DSL Routers
32
Instant Broadband
™
Series
31
Installing the Windows XP Driver
1. With the router connected to your PC’s USB port, start up your PC in
Windows XP, and insert your driver disk.
2. Windows will notify you that new hardware has been detected (shown
above). Select “Install from a list or specific location (Advanced),” and
click the Next button.
3. Select “Search for the best driver in these locations.” Then select “Include
this location in the search:” and enter “A:\” in the location field. Click the
Next button.
4. When the Hardware Installation screen appears, click Continue Anyway.
4. Windows will display a message saying that it has finished installing the
driver files on your PC. Click the Finish button.
5. Click the Start button and then Control Panel. Double-click Network
Connections and then Local Area Connection. Click Properties. Check
for Internet Protocol (TCP/IP) to make sure that TCP/IP is installed on
your PC. If TCP/IP is not installed, please refer to your Windows XP user
guide.
Your USB installation is now complete.
Continue on to the next page to configure
your network to work with the Router.
